Kit of parts
Below is listing of parts included in the kit sold on Tindie.
LED strips (2m, 144 LED/m APA102 or compatible, black PCB)
Bag A: materials for LED assemblies
two power distribution boards (PDB),
two 2x3 pin headers (to be soldered to the PDBs)
22AWG solid core wire (to be soldered to LED strips)
3d printed press tool, to be used for pressing the PDBs into the dowels. Discard after use
Note: color of the wire and press tool may vary.
Bag B:
Charge connector
3d printed housing for charge connector
2-pin wire (55 cm, 24 AWG)
Charging adapter (USB C to 5.5mm barrel jack)
Bag C:
Switch
3d printed housing for the switch
2-pin wire (55cm, 20 AWG)
Bag D: battery assembly components
two 2-pin wires, with JST XH connector
3d printed spacer, to go between batteries
Two 3d printed spacers to go at the ends of batteries
3d printed “plugs”
4-pin wire (22cm, 22AWG)
Wire, 5.5 cm, 22 AWG
Bag E: electronics
QT Py ESP32-S3 MCU, preprogrammed
Custom-made POV controller board (blue), containing Inertial Motion Unit, battery charge circuit, and more.
Switch connector board (black)
Two 7-pin headers
Bag F:
two shrink wrap sleeves
two foam sleeves
3-4. two 3d printed end protectors
tennis grip tape
Foam washers